User's Manual

ManualsBrandsLegrand ManualsElectronics802.11ac Dual Band In Ceiling WAP

Owner’s Manual of DA1104

-37-

a region other than one of those specified in this field. If your country or

region is not listed, please contact your local government agency for

assistance.

Band Select the desired mode. Default is “5GHz (A+N+AC)”. It is strongly

recommended that you set the band to “5GHz (A+N+AC)”, and all of

802.11a, 802.11n, and 802.11ac wireless stations can connect to the

DA1104.

 5 GHz (A): 802.11a mode, rate is up to 54Mbps

 5 GHz (N): 802.11n mode, rate is up to 300Mbps

 5 GHz (AC): 802.11n mode, rate is up to 867Mbps (2T2R)

 5 GHz (A+N): 802.11a/n mode, rate is up to 300Mbps

 5 GHz (N+AC): 802.11n/ac mode, rate is up to 300Mbps or

867Mbps

 5 GHz (A+N+AC): 802.11a/n/ac mode, rate is up to 54Mbps,

300Mbps, or 867Mbps

Mode

There are four kinds of wireless mode selections:

 AP

 Client

 WDS

 AP+WDS

If you select WDS or AP+WDS, please click “WDS Settings” submenu

for the related configuration. Furthermore, click the “Multiple AP”

button to enable multiple SSID functions.

SSID

The ID of the wireless network. User can access the wireless network

via its ID only. However, if you switch to Client Mode, this field becomes

the SSID of the AP you want to connect with.

Default SSID: Legrand AP 5G

Channel Width You can select 20MHz, 40MHz or 80MHz.

Control Sideband You can select Upper or Lower.

Channel Number

You can select the operating frequency of wireless network.

Broadcast SSID

If you enable “Broadcast SSID”, every wireless station located within

the coverage of the DA1104 can discover its signal easily. If you are

building a public wireless network, enabling this feature is

recommended. In private network, disabling “Broadcast SSID” can

provide better wireless network security.

Default is “Enabled”.

Data Rate

Set the wireless data transfer rate to a certain value. Since most of

wireless devices will negotiate with each other and pick a proper data

transfer rate automatically, it’s not necessary to change this value

unless you know what will happen after modification.

註解 [MSR2]: Where is this

field?