Specification Sheet

7877
INSTALLATION GUIDELINESINSTALLATION GUIDELINES
1
When replacing existing dimmers, label
wires before disconnecting.
Disconnect old dimmer.
DO NOT USE
PLATE INSTALLED
WITHOUT A WALL
TOP
Remove spacers from the frame. Since
this dimmer fills the frame completely,
youwillnotneedthespacers.Fromthe
back of the frame, pinch the tabs on the
spacer to release.
Common/Hot
DO NOT USE WITHOUT
A WALL PLATE INSTALLED
TOP
Frame
Paddle Dimmer
Wall Plate
Ground Wire
Spacers
WARNING
To prevent severe shock or electrocu-
tion, always disconnect power at the ser-
vice panel before beginning work.
3-Way
In a 3-Way circuit, identify the
Common/Hot wire — connected to
the terminal marked Common or
the odd-colored terminal screw.
Single Pole
For more information and helpful
how-to videos, visit
www.adornemyhome.com/install.
Use only with Legrand adorne
TM
system.
INSTALLATION INSTRUCTIONS
Please read these instructions com-
pletely before you begin. adorne
TM
dimmers are designed for installation
in standard electrical boxes. However,
some of the installation methods vary
slightly from traditional methods. If you
do not understand these instructions
or are unsure of your abilities, seek the
assistance of a qualified electrician.
CAUTIONS
To reduce the risk of overheating and
possible damage to other equipment,
do not install incandescent dimmer to
control a receptacle, a fluorescent light
or bulb, a motor-operated appliance, or a
transformer-supplied appliance.
Do NOT use dimmer with incandescent
lamps whose power requirements exceeds
maximum wattage of the dimmer.
Do NOT connect dimmer to power source
other than 120VAC, 60 Hz.
2
If necessary, cut wires and strip
insulation using stripping guide on back of dimmer.
STRIP GAGE
3
TIPS
•Pre-foldwiresintowallboxto
make it easier to fit them in the
box when dimmer is connected.
•Usecautiontoavoidmarring
wall surface with the metal frame.
WARNING
Failure to connect the ground
wire will result in an unsafe
installation that could lead to
personal injury.
Connect frame ground wire to bare ground
wireinbox.Foldgroundwiresintobackof
box. Mount frame to wall box with screws
provided. Tighten screws just enough to
hold frame in place. Do NOT over-tighten.
(to 10 in. lbs.)
Sample Installation: Paddle Dimmer | Catalog Number: ADPD703H