Specification Sheet

UNDER-CABINET LIGHTING SYSTEMUNDER-CABINET LIGHTING SYSTEM
How to Specify the System
The adorne Under-Cabinet Lighting System is a fully customizable and modular solution for eliminating kitchen clutter. It is compatible
with any kitchen layout, such as a galley, L-shaped, or U-shaped, as well as with any home wiring. In order to ensure you have specified
the correct products for your system, we recommend you follow the steps outlined below.
2. Selecting the Control Box and Power Options
 Next,selectthetypeoflightingandpowerconnectionyou’dliketoinclude.Forasimpleinstall,thePlug-InControlBoxprovides
 theeasiestsolution.Forahardwiredinstallation,thereareveoptionstochoosefromwhichenableexpandedlightingcontrol
options such as dimming:
• ControlBoxwithPaddleDimmer
• ControlBoxwithPaddleDimmerandGFCIprotection
• ControlBox,1-Gang(NoDevices)
• ControlBox,2-Gang(NoDevices)
• DirectWireConnector
 Forhardwiredinstallations,theremustbethreeseparatecircuitsfromtheelectricalpanel:
• ReceptacleCircuit:20Amps;GFCI-protected;Use#12wire
• LightingCircuit:15Amps;Use#12or#15wire
• AccessoryCircuit:15Amps;Use#12or#14wire
Compatiblewithalladorne2-moduledevices.TheCFL/LEDPaddleDimmer(ADPD453LM2)
is recommended for use with the adorne system.
3. Selecting the LED Lights
The adorne Under-Cabinet Lighting System is only compatible with adorne LED lights. These are available in Puck and Linear
versions. Recommended placement for lights is every 18” along Modular Track.
You can select any combination of Puck and Linear lights to complete your system. In addition, if you are mounting a light under the
cabinet and wish to move it further to the front of the counter, you can use the LED Light Extender. This enables you to increase the
length of any light from the Modular Track from a standard 11” to up to 22”. This is especially useful in corner installations.
4. Choosing Accessories to Complete the System
The final step is to select the accessories to perfectly complement your system. adorne offers a range of options, including USB
charging ports, mobile and tablet cradles, and a Digital Music Kit. Each of these accessories provides flexibility in that it can be
addedorremovedatanytime–simplyswapitwithanexistingoutletorblankmoduletoincreaseyoursystemcapabilities.For
more detail on accessories, see page 60.
1. Planning Your System Layout
First,determinewhereyouwanttoinstallthesystem.
Then measure your cabinets to determine the length of
Modular Track required:
• Measureeachcabinetlengthatbackofcabinet.
• Forinstallationswithacorner,allow3”oneachside
for Corner Connector.
• WhentotalingupthelengthofrequiredModularTrack,
be sure to include the length of the desired Control Box or
 DirectWireConnector.Fora1-gangbox,allow5”.
 Fora2-gangbox,allow5.25”.ForDirectWireConnector,
 allow6”.FormoredetailonControlBoxoptions,seepage58.
• IfyourselectionofModularTracksdoesnotmatchtheexact
length of your cabinets, you can use a Modular Track Extender
to complete the track. This piece can be cut down to 6”.
Standard 12”, 18”, and 27” Modular Tracks cannot
be shortened.
2G
1G
1G
18
27
27
18
27
18
12
EX
12 EX DWC27 2718
c
c
c
(cut to 6.75”)
(cut to 9.75”)
12” Modular Track
18” Modular Track
18” Modular Track Extender
2-Gang Control Box
with Paddle Dimmer
and 15A GFCI
Modular Track Corner Con-
nector
1-Gang Control Box
with Paddle Dimmer
LED Puck Light LED Linear Light Light Extender
Direct Wire Connector
27” Modular Track
Plug-In
Control Box
Control Box,
No Devices, 1-Gang*
Control Box,
No Devices, 2-Gang*
• One2-GangControlBoxisplacedat
one end of system for hardwired power
connection and lighting control
• Totallengthofcabinetscanbeexactly
matched with combination of standard
Modular Tracks
• Asneeded,ControlBoxescanbeplaced
anywhere in system
• 1-GangControlBoxesareplaced
at both ends of the system for hardwired
power connection and lighting control
• ModularTrackExtenderiscustom-cut
to match exact length of cabinets
• DirectWireConnectorisplacedat
one end of system for hardwired
power connection
• Lightcontrollocatedinnearbywallbox
• GFCIcircuitbreakerlocatedin
electrical panel
*
Sample Installation: Length of cabinets is equal to
combined length of standard Modular Tracks
Sample Installation: Length of cabinets is greater than
combined length of standard Modular Tracks
Sample Installation: Direct wire with system controls
in a remote location
56”
57”
60”
33”
36”
36”
Visit www.adornemyhome.com to use the Under-Cabinet
System Planning and Configuration Tool
5655
Hardwired Control Boxes