User's Manual

1. Press on the ADMHRM4 until the LED begins ﬂashing (about 5 seconds ).

2. Tap the

paddle on the remote. The LEDs on all the adorne wireless devices

begin to ﬂash. You now have 5 minutes to complete this process.

3. See step 3 above.

4. See step 4 above.

5. To test, tap

on any room scene controller that is bound to the same room to

switch or fade included devices to off (dimmers go to 0%)

BATTERY INFORMATION

The ADMHRM4 operates using two 1.5V Alkaline AAA size batteries. The remote

goes to sleep whenever it is not performing a function. When asleep, its LED is

off. To check battery status, press any button to wake up the remote.

IMPORTANT: Observe the color of the LED immediately after you wake it up.

âWHITE indicates the batteries are good.

âRED indicates the batteries are getting weak and should be replaced.

The battery compartment is on the bottom of the remote. Gently press up on the

battery door latching tab, then lift the cover to expose the batteries. Replace the

batteries using the same brand. Observe the pole orientation (+ - ) illustration on

the bottom of the battery compartment. Wait for the LED to stop ﬂashing before

attempting to use the remote.

TROUBLESHOOTING

During house ID binding, the LED is not flashing on some devices.

â If LED is solid white before initiating house ID binding:

The device already has another house ID. Reset it to the factory default so that

it can be bound to the desired house ID. See “I made a conﬁguration mistake. I

need to start over” on the next page.

â ,I/('LVVROLGRUDQJHDIWHULQLWLDWLQJKRXVH,'ELQGLQJ

The device may be out of range of the initiating device. Add a MRR2

Wireless Repeater to boost signal range.

During binding or customizing, all LEDs stop flashing before I

press

The 5 minute binding process timer may have expired. Restart the timer by

repeating steps 1 and 2 of the procedure you were using. Notice that the devices

you previously excluded are ﬂashing green; those included are ﬂashing orange;

simply ﬁnish the process from where you left off.

I made a configuration mistake. I need to start over.

To reset any adorne wireless device to factory default settings, press and hold

until the LED changes to solid orange (approximately 10 seconds). During the

process, the LED ﬂashes orange. When complete, it becomes solid orange. The

device can then be reconﬁgured, exactly like any new device.