User's Manual

STANDARD OPERATION
The ADMHRM4 is shipped with most functions preprogrammed for ease of
installation and initial use. This section summarizes the default operation of
the remote. To make changes from this standard operation, such as changing
light levels and including or excluding devices from specific scenes, see
CUSTOMIZING OPERATION.
Paddle Functions
Use the rocker paddle to begin and end binding functions. It also functions as
an On/Off switch and a master light level Raise/Lower control for the room. All
devices bound to the same room as the ADMHRM4 are included in the paddle
operation (except fan controls).
Scene Button Functions
The smaller buttons, labeled A—D in the illustrations, are used to record and
recall scenes. You can write the function of each button on the label included
with the remote. All devices bound to the same room as the ADMHRM4 are
included in each scene button (except fan controls).
The following illustration shows the default operation for scene set 1-4:
NOTES:
1 Pressing and holding the paddle does not affect the operation of switched
devices. They will maintain their present state.
A
B
C
D
E
Tap once: Raise all room
devices to 100% (ON)
Press and hold: Raise the
current scene’s level
1, 2
Press and hold: Lower the
current scene’s level
1
Tap once: Lower all room
devices to 0% (OFF)
Tap once: All room
Dimmers / Switches
to to
100% ON
75% ON
50% ON
25% ON
0% OFF
Press and hold:
Saves the current
device settings as
the scene that is
recalled the next time
you tap this button.
See CUSTOMIZING
OPERATION.
Paddle Scene Buttons