User's Manual

ManualsBrandsLegrand ManualsElectronicsWireless Room Scene Remote

SET HOUSE ID

All adorne wireless devices installed in the same home must acquire the same

unique House ID before use. This process is known as house binding. Each

adorne wireless device is bound to all other adorne wireless devices in the

house.

New Installation

1. With all devices installed and

energized, make sure that every

adorne wireless device LED is

orange. If any LED is off, be sure

the circuit breaker is on and the

device is correctly installed. The

ADMHRM4 remote shuts down

when it is not in use. Press any

button to activate the remote and illuminate its LED.

2. Press

on any device paddle until the LED ﬂashes orange (about 5 seconds ).

This indicates that it has acquired a unique House ID.

3. Make sure that all other adorne wireless device LEDs are ﬂashing green,

indicating that they have acquired the same House ID. For ADMHRM4

remotes, be sure that the units are awake during the binding process. Press

any button to activate the remote and illuminate its LED.

4. Return to the device used in step 2, which is still ﬂashing orange. Press

until the LED changes to solid white (about 5 seconds ). All device LEDs in the

House change to solid white, indicating house binding is complete.

Adding an ADMHRM4 to an Existing Installation

If you’re adding or replacing a device in a adorne wireless installation that is

already operating, the new device must be bound to the same House ID as the

other adorne wireless devices in the house. After the new ADMHRM4 is powered

up, the LED should be solid orange. This indicates that it has not yet acquired a

House ID. To acquire the House ID for the existing system:

1. Press

on any previously bound device until the LED ﬂashes orange (about 5

seconds ).

2. Be sure that the ADMHRM4 is awake during the binding process. Press any

button to activate the remote and illuminate its LED. Verify that the new

ADMHRM4 LED is ﬂashing green, indicating that it has acquired the House ID.

3. Return to the same previously bound device used in step 1 and press

until

the LED changes to solid white (about 5 seconds ). All device LEDs should

now be solid white.

When you see

in the instructions,

ﬁrmly press and

hold both the top

and bottom of

the paddle until

the LED changes

(about 5 seconds ).