Use and Care Manual

2. Remove the rubber ring from between the plates.

3. Reassemble the side plates with a new rubber ring.

When reassembling the friction wheel assembly, make

sure that rubber ring is centered and seated properly

between the side plates. Tighten each screw only

one rotation before turning the wheel clockwise and

proceeding with the next screw on the other side of

the wheel. Repeat this process several times to ensure

the plates are secured with equal force between

90N.m(6 ft-lbs) and 130N.m(9 ft-lbs).

4. Slide the friction wheel assembly back onto the hex shaft. Make

sure the shift lever pin is in place in the bearing housing. Follow

the steps above in reverse order to reassemble components.

STORAGE

At the end of the season or if the snow blower will not be used for

30 days or longer, follow the storage instructions below.

1. Run the engine until the fuel lines and carburetor are empty

and it stops due to lack of fuel.

2. Remove the safety ignition key and allow the engine to cool.

3. Lubricate the machine as instructed.

4. Clean the exterior of the engine and the snow blower

thoroughly.

5. Touch up all rusted or chipped paint surfaces; sand affected

areas before painting, and use a rust preventative to prevent

the metal parts from rusting.

6. Tighten all loose screws, bolts, and locknuts. Repair or replace

any damaged parts.

7. Cover the machine and store it in a clean, dry place out of the

reach of children.

Refer to the Engine Manual for information on

storing your engine.

Figure 19

GEAR SHIFT ADJUSTMENT

1. Disassemble the lower end of the shift rod from the shift arm.

(See Figure 19 #1)

2. Loosen the lock nut in the upper end of shift rod. (See Figure

19 #2&3)

3. When the reverse position wrongly becomes to forward,

rotate the shift rod counterclockwise for 1-3 turns. When the

forward position wrongly becomes to reverse, rotate the shift

rod clockwise for 1-3 turns. (See Figure 19 #3)

4. Fasten the lock nut in the upper end of shift rod. (See Figure

19 #4)

5. Assemble the the lower end of the shift rod to the shift arm.

(See Figure 19 #5)

6. If still not work, repeat the steps #1-5 until it works correctly.

Service & Storage