Use and Care Manual

The gearbox was lled with lubricant to the proper level at the

factory. Unless there is evidence of leakage or service has been

performed on the gearbox, no additional lubricant should be

required. If lubricant is required, use GL-5 or GL-6, SAE85-95, EP

gear oil lubricant. Do not use synthetic oil.

Lightly lubricate all moving parts of the machine at the end of the

season or every 25 operating hours.

AUGER GEARBOX

GENERAL LUBRICATION

ENGINE

LUBRICATION

MAINTENANCE

Refer to the Engine Operator’s Manual.

When lubricating auger shaft, remove shear pins

to apply oil inside the shaft and around spacers and

ange bearings found at either end of the shaft.

Remove the wheels to apply grease the wheel shaft.

Do not allow grease or oil get on friction disc, friction

plate or belts. Do not excessively oil the machine;

extra oil may enter the traction drive and cause the

traction drive belt to slip.

Oil

Grease

SERVICE

REPLACEMENT SHEAR PINS

A pair of replacement auger shear pins and clevis pins are

included with your snow blower. Store them in a safe place until

needed.

X 2

Figure 14

Maintenance and