Use and Care Manual
CHUTE BRACKET
If the spiral at the bottom of the directional chute
control lever is not fully engaging with the chute
assembly, the chute bracket must be adjusted.
Loosen adjusting nuts on cable support bracket.
Slide the control cable up or down by threading
adjusting nuts to increase cable tension or provide
more slack.
Tighten nuts after proper adjustment is achieved..
To do so:
Loose the two nuts which secure the chute bracket
and reposition it slightly.
Retighten the nuts.
1.
1.
2.
2.
3.
10
mm
13
mm
18
mm
16
mm
30
mm
32
mm
X 2
Figure 10
16
Two-Stage Snow Blower
»
Operator’s Manual
Adjustment
|