Use and Care Manual

TOP
1
2
Hexagon Socket
Screw M5x10
Flange Keeper
2.
3.
Place the discharge chute facing forward over the chute
crank ange. (See
Figure 4b
)
DIRECTIONAL CHUTE CONTROL
1.
3.
4.
2.
3.
M6 X 30 X 6
4
X 3
Figure 4c
Figure 4b
Figure 5a
Figure 5b
X 2
5
M8 X 1
32 mm
10 mm
16 mm
19 mm
10 mm
13 mm
18 mm
16 mm
30 mm
32 mm
While one person holds the chute in place, have the other
person secure the three flange-keepers to the bottom of
the chute crank ange by sliding the bolts through the chute
base holes, sliding the keepers up from the bottom, then
securing them with the included nuts. (See
Figure 4c
)
Slide the loop of the side brace over the chute control lever
rst and leave loose for now.
Loosen the hexagon socket screw M5x10 on the universal
joint several circles, then insert the end of the directional
chute control lever into the universal joint and tighten with
allen wrench. (See
Figure 5a #1
)
Align the side brace from Step 1 with the upper hole on the
left handle, and slide the brace bolt through the hole (See
Figure 5a #2
). Secure to the handle with a curved washer and
then nger tighten the nut to secure to the handle bar. (See
Figure 5a #2
)
Make sure the spiral at the bottom fully engages with the
chute crank ange (See
Figure 5b TOP
) and tighten the two
bolts on the chute bracket. (See
Figure 5b
)
Be sure to tighten the nut on the side brace that secures the
directional chute control bar to the handle bar. (See
Figure 5a
#2
)
10 mm
13 mm
18 mm
16 mm
30 mm
32 mm
X 2
10 mm
13 mm
16 mm
19 mm
4
mm
10
Two-Stage Snow Blower
»
Operator’s Manual
Assembly
|
Two-person assembly is required. Please plan to
assemble the discharge chute when another person is
available to hold the chute into position while securing
the hardware.