Use and Care Manual
Skid Shoe
Scraper Blade
1/8” (3mm)
M8 X 25 Bolt
M8 X 20 Bolt
1
2
3
ASSEMBLY
HANDLEBARS SKID SHOES
2.
3.
1.
1.
4.
Keep the lower handle level and rmly tighten all the bolts
from the previous 3 steps (1-3).
Raise the upper handlebars into operating position and slide
two bolts and washers through the two holes on the right
side, and two bolts and washers through the two holes on
the left side. Secure in place loosely by nger-tightening the
nuts. (See
Figure 2b
)
Ensure the handlebars are level and tighten all four nuts.
Unscrew the cable nut, slide the cable into the cable holder and
tighten the nut. (See
Figure 2a #1
)
Loosen the two bolts on the sides of the transmission housing.
Slide the lower handle slots in-between the transmission and the
washer. Finger tighten the bolts to hold the handle in place. (See
Figure 2a #2
)
Align the holes in the lower handle with the upper holes on both
sides of the transmission housing. Insert the bolts and curved
washers and nger tighten to hold in place. (See
Figure 2a #3
)
5.
2.
4.
6.
1.
3.
This snow blower was partially assembled at the factory. To assemble your machine follow the below instructions.
Figure 2a
Figure 2b
M10 X 40 X 2
1
M8 X 45 X 4
2
Place the machine on a solid, level surface.
Elevate the front of the machine slightly so the scraper blade
is 1/8" above the ground, and slide a piece of cardboard
(about half the thickness of the snow blower box) under the
scraper blade to elevate slightly.
Attach the skid shoes to the sides of auger housing with the
bolts and nuts. The shorter M8X20 bolts should be in the front
holes while the longer M8X25 bolts in the rear holes. Move
the skid shoes down as far as possible. Be sure both skid shoes
are adjusted evenly. Tighten securely. (See
Figure 3
)
Sit the chute crank flange on top of the impeller housing.
Make sure the stop triangle points forward so that the
notched edge is on the left side and the pre-greased surface
is on the bottom. (See
Figure 4a
)
Remove the 1/8” (3mm) spacer you used from under the
scraper blade.
M8 X 20 X 2
3
M8 X 25 X 2
Figure 3
Figure 4a
10
mm
13
mm
16
mm
19
mm
DISCHARGE CHUTE
10
mm
13
mm
16
mm
19
mm
10
mm
13
mm
18
mm
16
mm
30
mm
32
mm
Chute Crank Flange
Stop Triangle
9
|
Assembly