Full Product Manual
2.
Remove the rubber ring
from
between the plates.
3.
Reassemble the side plates
with
a new rubber ring.
When
reassembling the
friction
wheel assembly, make
sure
that
rubber ring
is
centered and seated properly
between the side plates. Tighten each screw only
))
one
rotation
before turning the wheel clockwise and
proceeding
with
the next screw on the
other
side
of
the wheel. Repeat this process several times
to
ensure
the plates are secured
with
equal force between
90N.m(6 ft-lbs) and 130N.m(9 ft-lbs).
4. Slide the
friction
wheel assembly back
onto
the
hex shaft. Make
sure
the
shift
lever pin is in place in the bearing housing. Follow
the steps above in reverse
order
to
reassemble components.
GEARSHIFT ADJUSTMENT
1. Disassemble the lower end
of
the
shift
rod
from
the
shift
arm.
(See
Figure 19 #1)
2.
Loosen the lock
nut
in the upper end
of
shift
rod.
(See
Fisure
19#2&3)
3.
When
the
reverse position
wrongly
becomes
to
forward,
rotate
the
shift
rod counterclockwise
for
1-3 turns.
When
the
forward
position
wrongly
becomes
to
reverse, rotate the
shift
rod clockwise
for
1-3 turns.
(See
Figure 19 #3)
4. Fasten the lock
nut
in the upper end
of
shift
rod.
(See
Figure
19#4)
5.
Assemble the the lower end
of
the
shift
rod
to
the
shift
arm.
(See
Figure 19 #5)
6.
If
still
not
work, repeat
the
steps #1-5 until
it
works
correctly.
Figure
19
STORAGE
~
Ret~r
to
the
E~gine
Manual
tor
information
on
~
stormgyour
engme.
At
the end
of
the season
or
if
the
snow blower
will
not
be
used
for
30
days
or
longer,
follow
the
storage instructions below.
1.
Run
the engine until
the
fuel lines and carburetor are
empty
and
it
stops due
to
lack
of
fuel.
2.
Remove the safety ignition key and allow the engine
to
cool.
3.
Lubricate the machine
as
instructed.
23 I
Service
&
Storage
4. Clean the exterior
of
the engine and the snow blower
thoroughly.
5.
Touch up all rusted
or
chipped paint surfaces; sand affected
areas before painting, and use a rust preventative
to
prevent
the metal parts
from
rusting.
6.
Tighten all loose screws, bolts, and locknuts. Repair
or
replace
any damaged parts.
7.
Cover the machine and store
it
in a clean, dry place
out
of
the
reach
of
children.