Full Product Manual

SPARE ROLL PINS
The impeller is secured to the impeller shaft with roll pins.
Figure 15
6X37
X2 -=·
Two 6x37 roll pins for impeller are supplied as spare in the
hardware kit. Store them in a safe place until needed.
AUGER BELT REPLACEMENT
If the auger belt becomes worn, oil-soaked, or otherwise damaged,
proceed
as follows to replace the belt.
1. To prevent spillage drain all fluids, remove all fuel from tank
by running engine until
it stops. Remove the key to avoid
unintended starting and allow
unit to cool completely.
2. Remove the two screws that hold the belt cover in place and
set the cover aside.
(See Figure 16a)
Figure16a
3. Roll the auger belt off the engine pulley. (See Figure 16b)
Figure 16b
4. Carefully pivot the snow blower up and forward so that it rests
on the auger housing.
5. Remove the frame cover from the underside of the snow blower
by removing the screws which secure the cover.
(See Fisure 16c)
Figure16c
6. Release the spring from the connecting hole in the braking
bracket. Move the braking bracket away from the belt. Remove
the belt
from around the auger pulley, and slip the belt between
the support bracket and the auger pulley.
(See Fisure 16d)
Figure16d
7. Replace the auger belt by following instructions in reverse
order.
Service I 20