Full Product Manual
ASSEMBLY
This snow blower was partially assembled
at
the factory.
To
assemble
your
machine
follow
the
below instructions.
HANDLEBARS
1. Unscrew the cable nut, slide the cable into the cable holder
and
tighten the nut.
(See
Figure
2a
#1)
2.
Loosen the
two
bolts on the sides
of
the transmission housing.
Slide the lower handle slots in-between the transmission
and
the
washer. Finger tighten the bolts
to
hold the handle in
place.
(See
Figure
2a
#2)
3.
Align the holes in the lower handle
with
the upper holes on both
sides
of
the transmission housing. Insert the bolts and curved
washers
and
finger tighten
to
hold in
place.
(See
Figure
2a
#3)
4.
Figure2a
M10X40
X2
1111
Keep
the
lower
handle level and
firmly
tighten all
the
bolts
from
the previous 3 steps (1-3).
5.
Raise
the upper handlebars
into
operating position and slide
two
bolts and washers
through
the
two
holes on
the
right
side, and
two
bolts
and washers
through
the
two
holes on
the
left
side. Secure in place loosely by finger-tightening the
nuts.
(See
Ffsure 2b)
Figure2b
M8X45
X4
R--W
6.
Ensure
the
handlebars are level and tighten all
four
nuts.
9 I
Assembly
SKID
SHOES
1. Place
the
machine on a solid, level surface.
2.
Elevate the
front
of
the machine slightly so
the
scraper blade
is
1/8"
above
the
ground,
and slide a piece
of
cardboard
(about half the thickness
of
the snow blower box) under the
scraper blade
to
elevate slightly.
3.
Attach
the
skid shoes
to
the
sides
of
auger housing
with
the
bolts and nuts. The shorter
M8X20
bolts should
be
in the
front
holes while the longer
M8X25
bolts in
the
rear holes. Move
the skid shoes down
as
far
as
possible.
Be
sure both skid shoes
are adjusted evenly. Tighten securely.
(See
Ffsure 3)
Scraper Blade
Figure3
M8X20
M8X25
M8X25Bolt
1/8"(3mm)
Skid Shoe
X2
11
X2
4. Remove
the
1/8"
(3mm) spacer
you
used
from
under
the
scraper blade.
DISCHARGE
CHUTE
1. Sit
the
chute
crank
flange on
top
of
the
impeller
housing.
Make
sure
the
stop
triangle
points
forward
so
that
the
notched edge
is
on the
left
side and the pre-greased surface
is
on the bottom.
(See
Figure 4a)
Figure4a