Use and Care Manual

CONTROL CABLES CHUTE CLEAN-OUT TOOL
Disconnect the Z-ttings from the turnbuckles and hook them
into the lower holes in the clutch levers. Thread the turnbuckles
without turning the cables onto Z-ttings until there is no slack
in the cables. Do not overtighten the cables. Hold the ats on
the turnbuckles with pliers and tighten the jam nuts against the
turnbuckles. (See Figure 6b)
Fasten the clean-out tool to the mounting clip on the rear of the
auger housing. (See Figure 7)
Figure 6b
Lower Hole
Turnbuckle
Z-fitting
Jam Nut
1 2
3 4
DISCHARGE CHUTE
1. Sit the chute crank ange on top of the impeller housing. Make
sure the notched edge is on the left side and the pre-greased
surface is on the bottom. (See Figure 8a)
Figure 8a
a
b
a
b
10
Two-Stage Snow Blower
»
Operator’s Manual
Assembly
|
Figure 6a
Figure 7