Instructions / Assembly

Operation (continued)
Handle Height and Left/Right
Adjustment
□
□
To adjust the handle height just loosen the up/down lever
lock (DD) and push handle up or down to the required height.
Then tighten the up/down lever lock (DD).
See Figure 1-10.
To adjust the handle axis point just loosen the left/right
handle lock (KK) and rotate the handle left or right to the
required axis point. Then tighten the left/right
handle lock (KK). See Figure 1-11.
8
15 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Clutch Cable
Jam Nut
DD
KK
Figure 1-10
Figure 1-12
Figure 1-11
Clutch
Clutch Lock
□
□
□
□
□
9
Wire Tension Adjustment
□
Proper wire tension is critical to good performance. After
1/2 hour of operation, all cables may have to be adjusted.
After using the tiller for the first time check tension after
every 2 hours of operation.
TO INCREASE WIRE TENSION
Loosen upper jam nut ⑴
Turn the adjusting nut counterclockwise in 1/8”
increments ⑵
Tighten upper jam nut ⑴
Check adjustment.
This procedure can be repeated until conduit adjustment
bolts are fully adjusted. If no more adjustment can be
made, the wire may have to be replaced. See Figure 1-17
INCREASE DECREASE
TENSION TENSION
LOOSENLOOSEN
(1)
(2)
TIGHTEN