Full Product Manual

9
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Assembly
Assembling the Depth Regulator
□
□
Insert the depth regulator (C) through the protective
shields (D) opening into the top of the depth regulator
bracket with handle facing to the rear.
Insert depth regulator clevis pin (EE) through the depth
regulator bracket. Then insert the cotter pin (FF) to secure.
The top hole of the depth regulator tines should clear
the ground. See Figure 1-1.
□ Locate the plates with the pre-drilled holes on the rear part
of the tiller body. Align the protective shield (D) holes to the
plate holes. Insert M8x20 bolts (AA) with spring washers
(HH) and regular washers (GG) and tighten with a wrench.
The front plate requires two M8 nuts (BB) to secure.
See Figure 1-2.
3
1
Assembling the Protective Shield to
the Tiller Body
2
Assembling the Handle
The handle is attached to the tiller body when shipped by the throttle
cable only. You will need secure the handle following the next few steps.
□
□
NOTICE: This tiller is shipped without gasoline or oil in the engine.
Fill up the gasoline and oil BEFORE operating your machine.
Figure 1-1
Figure 1-2
C
FF
EE
Depth Regulator
Bracket
D
Tiller Body
Handle
DD
KK
JJ
II
CC
D
AA
HH
HH
BB
HH
GG
AA
AA
GG
GG
WARNING: Make sure the tiller protective shield is
installed in place before starting the machine.
Insert the armrest (JJ) to the bolt seated on the tiller frame.
Then insert the armrest spring washer (II) and hand tighten with
handle lock (KK).
Align handle openings over the armrest openings and insert
bolt M16x140 (CC) through the handle and armrest. Use the
handle lever lock (DD) to secure on the opposite side. Use a
wrech on the M16x149 bolt (CC) to hold the bolt in place while
you hand tighten the handle lever lock (DD) on the opposite side.
See Figure 1-3.
Figure 1-3