Full Product Manual

10
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Assembly (continued)
Assembling the Wheels
4
Assembling the Tines
6
Assembling the Bumper
5
Figure 1-5
L
R
Tiller Body
AA
BB
F
Figure 1-4
Figure 1-6
Tiller Body
B
B
FF
FF
Insert tines (E) on each side through the tine axle located on the
rear of the tiller. Align pre-drilled holes and insert clevis pin (LL)
then insert cotter pin (FF) to secure in place. See Figure 1-6.
WARNING: Make sure to install the wheel in the
correct direction. See Figure 1-4.
□
Insert the wheel (B) through the axle on the tiller body. Then
place the clevis pin (LL) through the hole on the wheel
through the axle to secure the wheel in place. Place the
cotter pin (FF) to lock in place. See Figure 1-4.
□
Insert the bumper (F) into the front end of the tiller body
just below the engine. Align the pre-drilled holes and
insert M8x20 bolts (AA) and M8 nuts (BB) and tighten.
See Figure 1-5.
□
E