Full Product Manual

9 HOMEDEPOT.COM

Please contact 1-877-527-0313 for further assistance.

Operation (Continued)

WARNING: Always wear eye protection with side shields

marked to comply with ANSI Z87.1. Failure to do so could

result in objects being thrown into your eyes and other

possible serious injuries.

COLD ENGINE

1. Place the handlebar with the throttle/speed control assembly

side ﬂat to the ground surface.

2. Move the engine On/Off switch to the “ON” (I) position.

3. Set the choke lever to the CHOKE position.

4. Slowly press the primer bulb 7-10 times or until fuel is visible.

5. While standing on the operator side of the auger, place your foot

on the handlebar that is on the ground to stabilize the unit. Grip

the other handlebar with the other hand and tilt the auger so

that the auger bit is off of the ground.

6. Holding the unit ﬁrmly, pull the recoil starter grip 2 times to

prime with fuel, then pull until engine starts. Use short pulls

and do not allow the rope to snap back. Do not pull more than 6

times.