Full Product Manual

13 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Maintenance
Make certain that the auger is kept clean and stored properly. DO
NOT expose the unit to extreme conditions, excessive dust, dirt,
moisture or corrosive vapors.
The owner/operator is responsible for all periodic maintenance.
Complete all scheduled maintenance in a timely manner. Correct any
issue before operating the auger. For service or parts assistance,
contact our help line at 1-877-527-0313.
WARNING: Never operate a damaged or defective auger.
Improper maintenance will void your warranty.
NOTICE: For emission control devices and systems, read and
understand your responsibilities for service as stated in the Emission
Control Warranty Statement of this manual.
CAUTION: DO NOT spray the auger power head with
water. Water can contaminate the fuel system and can
enter the engine through the cooling slots and damage the
engine.
WARNING: Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc., come in
contact with plastic parts. Chemicals can damage, weaken,
or destroy plastic which could result in serious personal
injury.
1
Cleaning and Adjusting the Spark
Plug(s)
1. Remove the spark plug cable from the spark plug.
2. Use a spark plug socket tool, or a 3/4 in. (19 mm) socket to
remove the plug.
3. Inspect the electrode on the plug. It must be clean.
4. Make certain the spark plug gap is set within limits. Refer to the
Specifications section for values.
SPARK PLUG GAP
5. Refer to the spark plug types in Specifications when replacing
the plug.
6. Carefully thread the plug into the engine.
7. Use a spark plug socket tool, or a 3/4 in. (19 mm) socket to
install the plug.
8. Attach the spark plug wire to the plug.
2
Cleaning the Air Filter
1. Using your fingers, turn the knob on the air filter cover
counterclockwise to loosen the air filter cover.
2. Remove the paper air filter element.
3. Clean filter by gently tapping it on a flat surface. If very dirty,
replace with a new filter.
4. Place the air filter back into the assembly.
5. Reattach the air filter cover.