Full Product Manual

CAUTION: If the auger bit will not turn in a hole, turn

engine off and remove auger bit from the hole. Check auger

bit for damage and remove any debris from auger bit or

hole. Secure spark plug boot away from the engine and

frame to alleviate potential arcing.

Transporting the Auger

WARNING: Before transporting the auger, shut off engine,

wait for all moving parts to stop, and disconnect spark plug

wire and move it away from spark plug. Failure to follow

these instructions could result in personal injury or property

damage.

1. Disassemble the auger bit from the power head by removing

the open triangle looped end of the double wire snap from the

exposed end of the Ø 9.5 x 45 mm clevis pin and removing the

clevis pin from the auger bit and power head output shaft. This

will disengage the bit from the power head output shaft.

2. Carry the power head by the handle that does not have the

throttle/speed control with the recoil starter against your leg so

the fuel tank cap is pointed skyward while carrying the auger bit

in the other hand, held by the shaft.

Transporting the Auger