Full Product Manual

10
7. Once the engine starts, stand the auger up in the vertical
position and allow to run for 10-15 seconds.
8. After the engine runs for 10-15 seconds, move the choke lever
to the run position.
WARM ENGINE
1. Place the handlebar with the throttle/speed assembly side flat to
the ground surface.
Operation (Continued)
2. Move the engine On/Off switch to the “ON” (I) position.
3. Ensure that the choke lever is in the run position.
4. While standing on the operating side of the auger, place your
foot on the handlebar that is on the ground to stabilize the
unit. Grip the other handlebar with the other hand and tilt
the auger so that the auger bit is off of the ground.
5. Holding the unit firmly, pull starter handle until engine starts.
Use short pulls and do not allow the rope to snap back.