Operation Manual

22
Before calling service personnel, please check the following chart
for a possible cause to the trouble you are experiencing.
Perform the adjustments according to page 8 “Operation The
Monitor”
 If the problem you have experienced isn’t described below or
you can’t correct the problem, stop using the monitor and call
service personnel or your dealer.
Problem Check these things
No Display Ensure the power plug is installed correctly
on both ends.
Check the main power switch is set to “—“
Check that source equipment is
operating correctly.
Check the input signal is compatible
with this display.
The image is Check the input signal is compatible
not centered with this display.
The image is Check the input signal is compatible
not locked correctly with this display.
The remote control Make sure the batteries fresh and
doesn’t work are installed correctly.
Ensure the remote is aimed at the
IR sensor on the front of the display
The picture color Check the picture settings.
looks poor Reset the display.
If you are using YUV terminals, make sure
cables are correctly connected.
FCC Compliance Statement:
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the quick setup guide and user manual, may
cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct
the interference at their own expense.
Warning
This is a Class A product. In a domestic environment this product
may cause radio interference in which case the user may be
required to take adequate measures.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
EN 55022_EN 61000-3-2_EN-61000-3-3
EN 55024_IEC61000-4
EN 60950 [Low-Voltage Directive (73/23/EEC)]
Information in this document is subject to change without notice.
2011 Legamaster International B.V. All rights reserved.
Reproduction in any manner whatsoever without the written
permission of Legamaster International is strictly forbidden.
Trademarks used in this text: Legamaster and the Legamaster
logo are trademarks of edding AG; Windows is a registered
trademark of Microsoft Corporation, Nextwindow is a
registered trademark of Nextwindow.
Other trademarks and trade names may be used in this document
to refer to either the entities claiming the marks and names or
their products. Legamaster International disclaims any proprietary
interest in trademarks and trade names other than its own.
11  Troubleshooting 12  Compliance