Operation Manual

ManualsBrandsLegamaster ManualsMonitore-Screen FLEX

1 Connect the signal cable to monitor, then turn on computer.

2. Connect the USB cable with monitor and computer.

3. Turn on the monitor (AC switch on).

4. Connect one side of USB cable (Type-B USB connector) on the

monitor side. See below picture. (Check “Connection” section

for exact location).

5. Connect the other side of USB cable (Type-A USB) to the USB

port on computer.

6. Wait for 5 seconds and the touch function is ready to go.

It can be activated by pen, ﬁ nger, or any other pointer.

7. This touch monitor is Microsoft Windows 7 compatible. In order

to activate, go to

http://www.nextwindow.com/nextwindow_support/windriver.html

to download the latest driver.

Follow the direction in the NW Multitouch Device Driver

Installation Guide (part of the compressed ﬁ le along with

the driver) to install the driver.

8. Once the driver is installed, restart the PC and the touch

function is ready to go with MS Windows 7.

9. Operating Systems Supported:

I. Microsoft Windows:

i. Windows 2000, XP, Vista, and 7: Plug-and-play

ii. Driver required to run dual-touch/gesture on

Windows 7 (works as a digitizer)

II. Mac OS: Plug-and-Play, Single touch only.

III. Linux: Supports Knoppix (based on Debian) distribution

with the following requirements:

i. Linux 2.6 kernel series

ii. Evtouch Touchscreen Driver

http://www.conan.de/touchscreen/evtouch.html

iii. Single touch only

10. 4-Point Calibration Procedure: (Note: no calibration is

required for ﬁ rst time use, however, the touch panel might

be required for calibration over time depends on the usage)

I. Press the CAL button located next to the

USB connector (see page

8, item 4 for location) or press

the “Scroll Lock” key on the keyboard 6 times.

II. Wait for the beep sound, and the cursor will move to

near the upper left corner of the display automatically.

III. Place ﬁ nger, gloved hand, or any other pointer on the

cursor, and stay for 2 seconds (a beep sound will occur

when the pointer is placed on the cursor). Then the cursor

will move to near the upper right corner automatically.

IV. Repeat the procedure of item III until all 4 points is

calibrated. (see image below for the places where

cursor appears).

V. Conﬁ rm by tapping anywhere between the 4 points.

The calibration is completed and the touch monitor

is ready to be used now.

1. 2.

3.4.

8  Touch Operation