Instructions / Assembly

12
DANGER
WARNING
CARBON MONOXIDE HAZARD
For outdoor use only. Never us inside house, or other
unventilated or enclosed areas. This fire pit consumes air
(oxygen). Do not use in an unventilated or enclosed areas
to avoid endangering your life.
VERY HOT WHILE IN OPERATION
Never lean over the fire pit while in use. Do not touch
surfaces while the fire pit is in operation. Wait until the fire
pit has completely cooled down after use. Failure to
comply with these instructions may result in serious bodily
injury.
Caution: Do not attempt to operate until you have read and understand all General Safety Information in this manual and
all assembly is complete and leak checks have been performed.
Before Turning Gas Supply ON:
1. Your fire pit was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or any other
enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or liquids.
3. Ensure that there is no obstruction
to air ventilation. Be sure all gas connections are tight and there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing is replaced
and fastened prior to starting.
Before Lighting:
1. Fire pit should be thoroughly inspected before each use, and by a qualified service person at least annually. If relighting
a hot fire pit, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of exces
siv
e abrasion, cuts, or wear. Suspected areas should be leak tested. If
the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly specified by
manufacturer. The burner must be replaced prior to the appliance being put into operation if it is evident that the burner is
damaged. The replacement burner should be specified by manufacturer.
OPERATION INSTRUCTIONS
OFF
LOW
IGNITOR
OFF
P
U
S
H
T
O
T
U
R
E
N
LOW
IGNITOR
OFF
P
U
S
H
T
O
T
U
R
E
N
LOW
IGNITOR
HIGH HIGH
HIGH
Lighting:
1) Make sure the control knob is in the “OFF” position (Figure A).
2) Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge air from gas lines before
proceeding.
3) Push in gas control knob, turn counterclockwise to “LOW” (Figure B), and press the RED Ignitor button to light the fire
pit. If needed, keep the control knob depressed and continue pressing the RED Ignitor button until the fire pit lights
(you
should h
ear a clicking sound).
4) After the fire pit lights, release control knob. To increase the flame, turn the control knob counterclockwise to "HIGH"
(Figure C). To decrease the flame, turn the control knob clockwise to “LOW”.
Note: If burner fails to remain lit, all valves should be closed and a waiting period of at least 5 minutes should pass before
attempting to light.
Figure A Figure B Figure C