Owner's manual

ManualsBrandsLegacy Classic Furniture ManualsFurnitureNursery Crib Drawer 490-8910C

Assembly Instru

ction

10 CRIB DRAWER

Page

Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts that

may have come loose inside the carton during shipment

MPORTANT SAFETY INSTRUCTIONS



Please carefully read all instructions

before ass

embling the drawer box kit



Use only vendor’s supplied hardware to assemble. Usi

ng unauthorized hardware could j

eopardize the

structural integrity of the item.



For your safety and ease, assembly by two or more adults is recommended.



Keep instructions for

future use

PARTS INCLUDED

(A)

Front panel

–

1pc

(B) Back panel

eft Side Panel

(D) Right Side Panel

(E) Divider Panel

(F) Bottom Panel

(

)

Drawer Stops

Summary of content (5 pages)

PAGE 1
Assembly Instruction 490-8910 CRIB DRAWER Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts that may have come loose inside the carton during shipment IMPORTANT SAFETY INSTRUCTIONS:  Please carefully read all instructions before assembling the drawer box kit  Use only vendor’s supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural integrity of the item.
PAGE 2
Assembly Instruction 490-8910 CRIB DRAWER HARDWARE ENCLOSED: (H) Hex bolt screws: M6 x 20 – 2pcs (K) Caster – 4pcs (I) Cam bolt - 10pcs (L) Wooden Screw - 8pcs (J) Cam nut - 10pcs (N) Hex bolt screws M6 x 20 - 4pcs TOOLS REQUIRED: (M) Hex Allen Wrench with Ball tip -1pc (Included) Phillips Screwdriver (not included) PRE-ASSEMBLY:  Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface, as this will avoid damaging parts during assembly.
PAGE 3
Assembly Instruction 490-8910 CRIB DRAWER Fig (1) 3. Slide the Bottom panel (F) onto the groove of the Left Side Panel (C), Right Side Panel (D) and Back panel (B). Connect these panels together with Cam Nut (J) using Screwdriver to tighten. (See Fig 2) Fig (2) 4. Assemble the end of Divider (E) into the Back Panel with Bolt (H) using Allen key (M). 5.
PAGE 4
Assembly Instruction 490-8910 CRIB DRAWER Fig (3) 6. Turn the whole unit back side up and insert the same Bolts (H) through the Bottom Side Panel (F) into the Divider panel. Also, install the Caster (K) into the Bottom panel (F) with Wooden screw (L) using Screwdriver. Tighten all connections. Assembly is complete. (See Fig 4) Fig (4) 7. Push the whole unit under Crib or Toddler Bed/Daybed.
PAGE 5
Assembly Instruction 490-8910 CRIB DRAWER Fig (5) NOTE: This Crib drawer could also be used on a Convertible Crib or Toddler bed CARE INSTRUCTIONS:  Dust often using a clean, soft, dry lint-free cloth.  Blot spills immediately, and wipe with a clean, damp, cloth.  We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish.  If the crib is to be stored, store in cool dry place and carefully package all original hardware to protect from loss or damage.