INSTALLATION, OPERATING & MAINTENANCE INSTRUCTIONS C1-1104 (LB 1224) CROSS HANDLE CONNAUGHT 3-HOLE BASIN MIXER WITH POP-UP WASTE
Contents Dimensions 3 InstalLation Procedure 4 Parts List 6 Fault Finder 7 Safety Tips, Care and Maintenance 8 Guarantee 9 2
Dimensions in Inches (& Millimetres) 6"~12" 1 1/2~2" (38.1~50.8mm) 8" (203mm) 1 1/2-18UNEF-2A (103mm) 4 1/16" (Ø54mm) 1/16"~1 11/16" Ø2 1/8" 2-1/2-14NPSM (1mm~43mm) (27.5mm) 1 1/16" (12.7mm Min) 1/2" Min 3 1/2" (126mm) (90mm) 4 15/16" (Ø46.5mm) 3 7/8" Ø1 13/16" (99mm) (Ø55mm) 2-G1/2 Ø2 3/16" 2-9/16-24UNEF (152mm~305mm) 12" Max (305mm Max) Ø1 1/4" (Ø31.
Installation Procedure Steps 1-2 Lefroy Brooks always recommends that plumbing products be installed by a licensed professional. Shut off main water supply before installation. Hot Cold 1 1 Install the Hot and Cold side-body and handle assembly. 2 Fix the spout.
Installation Procedure Steps 3-4 Lefroy Brooks always recommends that plumbing products be installed by a licensed professional. Shut off main water supply before installation. 3 3 Install the Pop-Up Waste. 4 Install the hose.
Installation Procedure Step 5 Lefroy Brooks always recommends that plumbing products be installed by a licensed professional. Shut off main water supply before installation. 5 5 After installing faucet, open the hot and cold supplies to check for leaks. Turn on faucet handle for one minute to flush debris from faucet. Turn off the handle. Warning! When installing flexible hose, please notice: 1. There should be no torsion or deformation 2. Do not fold into a V or L shape. 3.
Parts List Exploded view 16 17 35 39 18 1 19 2 20 3 21 4 22 5 23 6 24 7 25 8 26 9 27 40 10 28 38 36 11 29 12 30 13 37 31 14 32 15 33 34 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Ceramic cap ( C ) (129312C) Cross handle (029721-T) O-ring (048085) Canopy (018220) Washer (013570) Screw (008670) Clip (012242) Stem extension (110461) Escutcheon (215486) O-ring (004627) Cartridge assembly ( H )(507907W) Oil-seal (010017) Washer (013158) Nut (009834) 15 16 17 18 19 20 21 22 23 24 25 2
Fault Finder Fault Cause Rectification Leaks around handle. Cartridge has come loose or damaged. Tighten/reinstall the cartridge or replacement the cartridge if it is damaged. Leaks around the base of spout. Gasket is misfitted or damaged. Check for gasket placement. Aerator leaks or has an inconsistent water flow pattern. Aerator is dirty or misfitted. Unscrew the aerator to check rubber packing or replace the aerator.
Safety Tips, Care and Maintenance Safety Tips If you are soldering during faucet installation,remove cartridges, seats, gaskets and washers prior to applying flame, otherwise you will void the warranty. Cover drain openings to avoid losing small parts. When cutting or soldering pipe, use safety glasses to protect your eyes. Important Points Prior to beginning installation. turn off the cold and hot water lines and open the old faucet to release built-up pressure. Overtightening nuts may cause damage.
Guarantee Guarantee of Quality This product is guaranteed against faulty materials and workmanship for 12 months from date of purchase. For the guarantee to be valid, the unit must be installed by a competent person, in accordance with the instruction booklet. Any part found to be defective during the guarantee period, will (at our option) be repaired or replaced, free of charge, provided the unit has been installed, and properly used in accordance with the instruction booklet.
718-302-5292 www.lefroybrooks.com LEFROY BROOKS INC, 1828 TROUTMAN STREET, RIDGEWOOD, NY, 11385 TELEPHONE: 718-302-5292. FAX: 718-302-4177 The use of trademarks, product design and artwork is subject to licence or agreement with Christo A. Lefroy Brooks. The design registrations, trademark registrations and copyrights are protected by law and the use or reproduction outside the terms of an agreement is prohibited. The right to modify designs and dimensions is reserved.
