Installation and Operating Instructions

or three more times.

TRANSMITTER WALL CLIP

The transmitter can be hung on a wall using the clip provided. If the clip is installed on a solid wood

wall, drill 1/8" pilot holes and install with the screws provided. If It is installed on a plaster/wallboard

wall, first drill two 1/4" holes into the wall. Then use a hammer to tap in the two plastic wall anchors

flush with the wall; then install the screws provided.

BATTERY LIFE

Life expectancy of the alkaline batteries in the FC202-1/FC202-2 can be up to 12 months depending on

use of the solenoid function. Replace all batteries annually. When the transmitter no longer operates

the remote receiver from a distance it did previously (i.e., the transmitter's range has decreased) or the

remote receiver does not function at all, the batteries should be checked. It is important that the

remote receiver batteries are fully charged, providing combined output voltage of at least 5.5volts. The

transmitter should operate with as little as 2.5 volts battery power.

TROUBLE SHOOTING

If you encounter problems with your fireplace system, the problem may be with the fireplace itself or it

could be with the remote system. Review the fireplace manufacturers operation manual to make sure

all connections are properly made. Then check the operation of the remote in the following manner:

WALL CLIP

SLOT