Installation and Operating Instructions

every 4 seconds until a transmitter ON or MODE Button is pressed to reset the receiver. The
intermittent 4-second beeping will go on for as long as the receiver batteries last, which could be in
excess of one year.
To "reset the RECEIVER and operate the appliance, you must press the ON or MODE button on the
transmitter. By turning the system to ON, the COMMUNICATION -SAFETY operation is overridden and
the system will return to normal operation depending on the MODE selected at the transmitter. The
COMMUNICATION SAFETY feature will reactivate should the transmitter be taken out of the normal
operating range or should the transmitters batteries fail or be removed.
CP (CHILDPROOF) FEATURE
This remote control includes a CHILDPROOF "LOCK-OUT feature that allows the user to "LOCK-OUT"
operation of the appliance, the TRANSMITTER.
SETTING "LOCK-OUT"-(CP)
To activate the "LOCK-OUT" feature, press and hold the ON button and the MODE button at the same
time for 5 seconds. The letters CP will appear in the TEMP frame on the LCD screen.
To disengage the "LOCK-OUT, press and hold the ON button and the MODE button at the same time
for 5 seconds and the letters CP will disappear from the LCD screen and transmitter will return to its
normal operating condition.
To verify that transmitter is in the CP lock-out mode press any key and the LCD screen will show "CP"
NOTE: If the appliance is already operating in the ON or THERMO MODES, engaging the "LOCK-OUT"
will not cancel the operating MODE. Engaging the "LOCK-OUT" prevents only the manual operation of
the TRANSMITTER. If in the auto modes, the THERMO operation will continue to operate normally. To
totally "LOCK-OUT" the operation of the TRANSMITTER'S operating signals, the transmitter's MODE
must be set to OFF.
MATCHING SECURITY CODES
Each transmitter can use one of 16777216 unique security codes. It may be necessary to program the
remote receiver to LEARN the security code of the transmitter upon initial use, if batteries are replaced,
or if a replacement transmitter is purchased from your dealer or the factory. When matching security
codes, be sure slide button on the receiver is in the REMOTE position; the code will NOT LEARN" if the
slide switch is in the OFF position. Program the remote receiver to LEARN a new security code Press
and Release the LEARN button on the top of the remote receiver and then press any button on the
transmitter. A change in the beeping pattern, at the receiver, indicates the transmitter's code has been
programmed into the receiver. When an existing receiver is matched to a new transmitter, the new
security code will overwrite the old one.
The microprocessor that controls the security code matching procedure is controlled by a timing
function. If you are unsuccessful in matching the security code on the first attempt, wait 1 -2 minutes
before trying again-this delay allows the microprocessor to reset its timer circuitry--and try up to two