Installation and Operating Instructions

between SET temperature and ROOM temperature, which determines when the fireplace will be
activated.
The remote control has the manual function of turning on and off. The "ON" and "OFF" keys must be
executed at all times. When the "OFF" is pressed, a signal is sent to the receiver to perform the action
of closing the solenoid valve. At the same time, after 10 seconds, the display is turned off. When the
button on the remote control is pressed, the words “ON” or “OFF” appear on the LCD screen to
display when a signal is sent. When first used, there may be a 3 second delay before the remote
receiver responds to the transmitter. This is part of the system design.
SETTING °F/°C SCALE
The factory setting for temperature is °F. To change this setting to °C
Press the ON key and the OFF key on the transmitter at the same time. This will change from °C back
to °F. Follow this same procedure to change from °C back to °F.
BATTERY DISPLAY
The power display is divided into 4 files, 3 grids, 2 grids, 1 grid, and blank grid. When the blank cell
display flashes, it will be powered off after 5 seconds.
REMOTE RECEIVER（FC202-02）
IMPORTANT
THE REMOTE RECEIVER SHOULD BE POSITIONED WHERE AMBIENT
TEMPERATURES DO NOT EXCEED 130°F.
The remote receiver (right) works with 4 1.5 V AA batteries. The battery compartment is detachable
and can be detachably mounted to the fireplace panel or combined with the receiver on the side of the
fireplace. It is important to use alkaline batteries to extend battery life and maximize microprocessor
performance: new or fully charged batteries are critical to proper operation of the remote receiver
because of the high power consumption of the latching solenoid Higher than the standard remote
control system.
NOTE:
The remote receiver will only respond to the transmitter when the 3-position slide button on the
remote receiver is in the REMOTE position. The remote receiver houses the microprocessor that
REMOTE
RECEIVER
BATTRY
COMPARTMENT
SOLENOID OFF
REMOTE STATE
SOLENOID ON
LEARN BUTTON