Installation and Operating Instructions

the display lights up and the “M” icon goes out. Press the “MODE” button again to switch back to
the manual mode. The “A” icon on the display is off, and the “M” icon is on and the cycle is
switched.
TO CHANGE THE SET TEMPERATURE
In the automatic constant temperature mode, directly press the “∧” and “∨” keys to adjust the
target temperature value (the manual mode cannot be adjusted). When adjusting, the “TEMP” icon
is off. After the target temperature is adjusted, do not press any button. After 2 seconds, the target
temperature flashes 3 times and then changes to the ambient temperature display. “∧”, “∨” button,
when adjusting the target temperature, each time you press it, increase or decrease by 1 degree, long
press to increase or decrease rapidly.
a. If the adjusted target temperature is lower than the ambient temperature, the side flame icon is off,
and a signal is sent to the receiver to perform the closing solenoid valve action.
b. If the adjusted target temperature is higher than or equal to the ambient temperature, the flame
icon is on, and a signal is sent to the receiver to activate the solenoid valve.
NOTE: The highest SET temperature is 90° Fahrenheit (32° Celsius) and the lowest temperature is 42°
Fahrenheit (6° Celsius)
OPERATIONAL NOTES:
The Thermostat Feature on the transmitter operates the appliance whenever the ROOM
TEMPERATURE varies a certain number of degrees from the SET TEMPERATURE. This variation is called
the “SWING” or TEMPERATURE DIFFERENTIAL. The normal operating cycle of an appliance may be
2-4 times per hour depending on how well the room or home is insulated from the cold or drafts. The
factory setting for the “swing number” is 2. This represents a temperature variation of +/-2°F (1° C)
MANUAL FUNCTION
M ：BRIGHT, A： OFF
THERMOSTAT
FUNCTION
M ：OFF, A ：BRIGHT
WHEN ADJUSTING THE
TARGET TEMPERATURE,
TEMP IS OFF
WHEN THE TARGET
TEMPERATURE IS HIGHER
THAN OR EQUAL TO THE
AMBIENT TEMPERATURE,
THE FLAME IS BRIGHT.
WHEN THE TARGET
TEMPERATURE IS LOWER
THAN THE AMBIENT
TEMPERATURE, THE FLAME IS
EXTINGUISHED.
After adjusting the
target temperature,
when the temperature is
changed to the ambient
temperature for 3
seconds, the ambient
temperature value is
immediately refreshed.
(refresh every 2 minutes)