Installation and Operating Instructions

4.A：Thermostat function
5.M：Manual function
6. ：Remote control battery display
7.
0
F or
0
C：Indicates degrees Fahrenheit or Celsius.
INSTRUCTIONS
When the remote control is loaded with the battery and any button on the remote control is pressed,
the full screen lights up. Then the ambient temperature is displayed. The default unit is °F, manual
mode, and the battery level is displayed.
MANUAL FUNCTION
In the manual mode of the operating system, please do the following.
ON OPERATION
Press the “ON” button to send a signal to the receiver to perform the action of opening the solenoid
valve. At the same time, the display shows “ON” for 3 seconds, it is converted to ambient
temperature display, and the flame icon is on. (The flame icon will appear on the LCD screen in manual
open mode)
OFF OPERATION
Press the "OFF" button to send a signal to the receiver to perform the action of closing the solenoid
valve. At the same time, the display shows “OF” for 3 seconds, it is converted to the ambient
temperature display, and the flame icon is off.
THERMOSTAT FUNCTION
Press the “MODE” button to switch to the automatic constant temperature mode. The “A” icon on