User guide

65 PROGRAM (PROGRAMFACTORYDEFAULTS)

 STOP(TB-1)andEXTERNALFAULT(TB-13D)circuitrymaybedisabledifparametersare

resettofactory defaults!The drive mustbe reprogrammedaftera RESETinorder toinsure

proper operation.

 FAILURETODOSOMAYRESULTINDAMAGETOEQUIPMENTAND/ORINJURY

TOPERSONNEL!

 This parameter is used to reset the programmable parameters back to the factory default settings. This

parameter has four possible settings:

MAINTAIN Maintain parameter settings as they are.

 RESET60 Resetsparameterstofactorydefaultsfor60Hzbasefrequency.

 RESET50 Resetsparameterstofactorydefaultsfor50Hzbasefrequency.

 RSTHIGH Resetsparameterstofactorydefaultsfor650Hzbasefrequency.Thisoptionwillonly

appearifthedriveisequippedwiththeHighFrequencyOutputoption.

When a factory reset is performed, the following terminals are affected:

TB-1 will be disabled because Parameter 30 - CONTROL will default to LOCAL.

TB-13A, 13B, and 13C will be disabled because Parameters 47, 48, and 49 will default to NONE. If

TB-13C was set to RUN REVERSE, TB-12A will default to a momentary START contact.

TB-13D will default to a normally open EXTERNAL FAULT contact because Parameter 50 - TB13D EXT

will be reset to FAULT.

NOTE: This parameter will display RESET 60, RESET 50 or RST HIGH until a change is made to one

or more of the parameter settings. Once a parameter is changed, the display will change to MAINTAIN.

66 HISTORY (CLEARFAULTHISTORY)

This parameter is used to clear the previous faults in the FAULT HISTORY. When set to CLEAR and the

ENTERkeyispushed,thedisplaywillchangetoMAINTAIN,andtheFAULTHISTORYwilldisplay

NO FAULT for each of the eight fault histories.

69 LANGUAGE (LANGUAGESELECTION)

The MICRO Series drive can support other languages with the addition of an optional LANGUAGE

EEPROMchipinstalledinsocketU11onthecontrolboardofthedrive.IFtheEEPROMisnotpresent,

the default language will be ENGLISH. Also, this parameter is not affected when the parameters are reset

using Parameter 65 - PROGRAM. Therefore, if a language other than ENGLISH is selected, it will remain

in effect after a RESET.

WARNING