User guide

NOTE 2: If a RESET command (Parameter 65 - PROGRAM) is issued through the serial link, this

parameter will not default back to DISABLE. However, explicitly setting this parameter to DISABLE

throughtheseriallinkwillcutoffcommunicationwiththedrive.

If developing an application for serial communications, refer to the RS-232/RS-485 Modbus

Communications Protocol Specification.

58 ADDRESS  (SERIALADDRESS)

This parameter is used with the serial communications feature, and is intended for use in a multiple drive

network(RS-485).Theseriallinkwillsupportdriveswithaddressesfrom1upto247.

61 PASSWORD (PASSWORDNUMBER)

This feature limits access to the programmable parameters for added security. The correct password must be

entered in order to change any parameter settings.

 Pressing the PROG/RUN button on the keypad will call up the PASSWORD prompt. If the correct

password is entered, the PROGRAM MODE is entered and parameters can be changed.

If the wrong password is entered, the drive will flash ERROR: INCORRECT on the display and then return

to the PASSWORD prompt to allow another attempt at entering the correct password.

 Ifthe ENTER key is pressed while PASSWORD reads 0000, the MONITOR MODE willbeentered

(ifParameter64 -MONITOR,issettoON),whichwillallowthe parameterstobeviewed(exceptfor

PASSWORD),butnotchanged.

NOTE 1: The factory default value is 0019.

NOTE 2: Programming PASSWORD to 0000 disables the function. When the password is disabled and

the PROG/RUN button is pressed, the user will enter the PROGRAM MODE directly, without having to

enter a password.

63 SOFTWARE (SOFTWAREVERSION)

This parameter displays the software code and revision number of the control board software. This

information is useful when contacting the factory for programming or troubleshooting assistance. This is a

“view-only”parameter,andcannotbechanged.

64 MONITOR (MONITOR)

 This parameter is used to enable (ON) or disable (OFF) the MONITOR MODE function. The

functionalityisexplainedbelow:

 ON  PressingthePROG/RUNkeywillcallupthePASSWORDprompt.IftheENTER

keyispressedwhilethepasswordvaluereads0000,theMONITORMODEisentered

andparameterscanbeviewed(exceptforPASSWORD),butnotchanged.

 OFF  PressingthePROG/RUNkeywillcallupthePASSWORDprompt.IftheENTER

KEY is pressed while the password value reads 0000(or any other incorrect value),

it will be treated as in incorrect password and the display will flash ERROR:

INCORRECT, and then return to the PASSWORD prompt to allow another attempt

at entering the correct password.