Daim Ntawv Qhia Tus Neeg Siv

UNITE® 200 Pro PTZ HD Camera

QSG-0142-001v1.0 September 2021

5 720p50 D -

6 1080p30 E -

7 1080p25 F -

Start Up

1. If you are not using the PoE Splitter, connect the AC power adapter to a power source.

2. On the back panel of the UNITE 200 Pro, set the Power Switch to On.

When the camera starts, Pan-Tilt rotates to the maximum position of top right, then returns to the center position. This

completes the initialization process.

Note: If the position preset 0 has been stored, then after initialization, the position preset 0 is called

up.

If you want to restore the factory default settings:

a. Press the Menu button to display the On-screen Display (OSD) menu.

b. Select Menu >Restore Default > Restore.

c. Set the value Yes, then press the HOME button.

IR Remote Control

Note: Power consumption in standby mode is approximately half of the normal mode

Standby Button

• Press this button to enter standby mode.

• Press it again to enter normal mode.

Position Buttons - to set or call a present

Zoom Buttons

• Slow Zoom: Zoom In [+] or Zoom Out [-] slowly

• Fast Zoom: Zoom In [+] or Zoom Out [-] fast

More detailed information about using the UNITE 200 Pro PTZ HD Camera is provided in the UNITE 200 Pro User Manual,

available in the ClearOne Resource Libary.