Installation Guide

5
4
5
Drill two 5/16” (8mm) pilot holes
(Fig 2).
Fold the anchor (D) in the middle by pressing
in middle with nger (Fig. 3).
Insert anchor in hole and tap ush with a ham-
mer (Fig. 4).
1
2
3
Using the antenna extension brackets or the
templates (g. 1; Pg. 2), mark the two (2) mounting
hole locations.
Hollow Wall Antenna Installation:
Determine required mounting location.
6
Use nail or small screwdriver to pop anchor open
behind hollow wall (Fig. 5; not necessary for thick or
solid walls).
Do not hammer nail or screwdriver.
7
Remove the nail or screwdriver.
8
Repeat steps 4 - 7 for the second anchor.
To avoid interference, only one anchor should
be installed vertically.
9
Secure antenna extension bracket (A) using
two (2) wood screws (B) (Fig 6).
Do not overtighten screws.
Hollow wall anchors (D) may be used as wedge anchors in walls thicker than 3/4”
or as expansion anchors in solid walls.
Fig. 3
Wall
Anchor
Fig. 4
Wall
Anchor
Flush
Fig. 5
Wall Anchor
open in wall
Fig. 6
Secure
Bracket to
Wall
Fig. 2
Wall
Anchor
ClearOne
®
DIALOG
®
20 and DIALOG
®
10 USB
_____________________________