Use and Care Guide

3 HOMEDEPOT.COM/ECOSMART
Please contact 1-877-527-0313 for further assistance.
Pre-Installation
Package Contents
Operation
The following are the general procedures for this smart bulb to be “included” into the
network.
FCC Regulation
FCC ID: 2AB2QA9A19A60WESDZ2
4
Operation
(continued)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. This equipment, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Any changes or modications not expressly
approved by the manufacturer could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures: reorient
or relocate the receiving antenna; increase the separation between the equipment and receiver; connect the
equipment into an outlet on a circuit different from that to which the receiver is connected; consult the dealer or
an experienced radio/TV technician for help.
Part Description Quantity
A A19 LED Bulb 1
User GuideB 1
1
Screw the bulb into a standard E26/E24 socket.
2
Open Amazon Alexa (if you are using Amazon Echo Plus), Wink or
SAMSUNG SmartThings App.
3
Add the smart LED bulb to the hub.
4
Control your lighting
See reverse side for specic Amazon Alexa (only if you are using Amazon
Echo Plus) Wink and SmartThings instructions
Dimming
The LED bulb will dim to 1% -100% range using the hub app.
Reset to Factory Setting
Color Tuning
Use the hub app to adjust Color Temperature (CCT) of the LED bulb.
Download or update your hub manufacturer’s app.
Turn on the LED bulb with the wall switch.
The LED bulb will ash twice when turned ON to indicate that the bulb is in pairing mode.
Open hub manufacturer’s app and follow pairing instructions. See reverse side for specic Amazon Eco Plus,
Wink and SmartThings instructions.
After successful pairing with the hub the LED bulb will ash twice.
Control the LED bulb through your device (the wall switch mush remain ON).
The LED bulb will be ready to control only after successful pairing to the hub.
The LED bulb is not designed to work with wall dimmers or other controlled lighting systems.
If using a dimmer with this LED bulb, set dimmer at the highest setting for best results.
Works with Amazon Eco Plus, Wink and Smart Things hubs only.
Refer to hub manufacturing instructions or website for scene setting, scheduling and any other app features.
□ Using the wall switch, physically switch ON and OFF 6 times within 2 seconds.
□ The LED bulb will flash twice after a successful reset.
Basic Instructions
NOTE: Ensure the hub is powered on and within range of this LED bulb.
NOTE: If the bulb will not join the network after repeated attempts, please use the Factory Reset
procedures to clear the bulb’s settings.
A
B