User's Manual

Chapter 5 Troubleshooting and Software Installation
5-1 LED Malfunction Alert
(1) Red LED flashing quickly (every 0.2 sec) when any pushbutton is pressed.
The problem could be:
(a) One of the pushbuttons is jammed.
(b) The EMS mushroom has not been released.
(c) The system is not properly powered according to the instructions.
*If a problem is found, please contact the distributor for repair.
(2) TX LED flashes slowly (every 0.5 sec).
The memory of the TX is defective. Contact the distributor for repair.
(3) RX Main LED flashes slowly (every 0.5 sec) but the relays are not operating at all.
The RX memory is defective. Please contact the distributor for repair.
(4) The TX LED flashes every 2 seconds when the battery power is low. Please
replace the new battery immediately.
5-2 Simple Troubleshooting
(1) TX LED remains ON with red light.
Please remove the batteries and insert again.
(2) The RX does not respond at all.
Turn the main power off for 20 seconds and turn it on again.
13