Lee’s Hi-tech Enterprise. Co., Ltd.
F25 -60 Operating Instructions Warranty Lee’s Hi-Tech Enterprises Co., Ltd. guarantees that this product meets its published specifications at the time of shipment from the factory. Under proper installation it should work as expected. Warranty Period This equipment is warranted against defects in material and manufacturing for a period of one year from the date of shipment. During the warranty period, TELECRANE is responsible for necessary repairs as long as the product can be proved to be defective.
Precautions 1. 2. 3. 4. 5. 6. Operating in an industrial facility is relatively dangerous; therefore, operator must have taken the adequate trainings in using F25 system. Those who operate the machine should be healthy and have good judgment in regard to safety. Although the F25 transmitter is so durable and resistant for the fluctuating temperature, care still need be taken to prevent it from the severe impact or pressure. If the severe interference occurred the equipment should be stopped at once.
Before ID code remote setting, please follow the instruction below, Make sure both TX and RX are same model and in the same frequency channel. Receiver JP1 jumper must be installed in order to perform ID code remote setting. To avoid interference during remote setting, have transmitter closer to RX as possible. Receiver AC power supply must be disconnect and turn on again after 20 seconds. (ID code remote setting must be completed within 4 minutes after receiver is being turn on again).
Transmitter green/Yellow LED indicator flashing crossly when start key switch on Transmitter red/yellow LED indicator flashing crossly when start key switch on Red LED indicator flashing quickly when start key switch on Transmitter red LED indicator remains on permanent Receiver LED1 indicator flashing quickly The joystick #1 memory is damaged. Contact the distributor for service. The joystick #2 memory is damaged. Contact the distributor for service. Transmitter main memory is damaged.
Industry Canada Notice Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Industry Canada Caution This device complies with Industry Canada licence-exempt RSS standard(s).
