User's Manual

Power Supply Selection
F25 receiver provides with 4 kinds of Transformer (24V/42V/230V 、
48V/110V/220V、110V/220V/380V、48V/220V/380V) that allows user to choose
based on the power input on site and the designated voltage will be set when the
receiver is made in factory.
Changing power supply voltage
3-4-1 Disconnect the power of receiver.
3-4-2 Remove the connector plug of the transformer from its original position.
3-4-3 Insert the connector plug into the new position.
3-4-4 Complete the procedure.
Note:Users are allowed to select the different power source according to the
respective requirement. However, the transformer must be changed. Please check with
your local distributor for replacement of the transformer if necessary.
Inspection and Fault Detection
Inspection
Daily inspection is important and will ensure the safety of operation. Inspection
should include "emergency stop" and other safety devices and functions. If there is
any doubt, operation must be stopped immediately and problems must be solved
before resume of operation.
Fault Detection
F25 is equipped with simple fault detection mechanism. While start and during the
operation, fault detection mechanism will indicate the faulty signals if any
malfunction is detected. Operator must understand the faulty signals and notify the
maintenance personnel.