User Manual

LeddarVu – User Guide Page 108 of 129
Figure 65 presents an example of raw detections. When there is no detection in some segments,
only the segments where a detection occurred appear in the list.
Figure 65: Example of detection filters
The following is a description of the parameters available in the Raw Detections dialog box.
Min and Max Amplitude
The value entered in the Min Amplitude box shows only detections of amplitude higher or equal
to that value. For example, if the minimum amplitude is set to 5, only the detections of amplitude 5
and more will be displayed.
The value entered in the Max Amplitude box will show only detections of amplitude lower or equal
to that value. For example, if the maximum amplitude is set to 8, only the detections of amplitude
8 and lower will be displayed.
Setting a value in both fields will result in a range of amplitude to display.
Min and Max Distance
The value entered in the Min Distance box will show only detections at a distance greater or equal
to that value. For example, if the minimum distance is set to 10, only the detections at a distance
of 10 and more will be displayed.
The value entered in the Max Amplitude box will show only detections at a distance smaller or
equal to that value. For example, if the minimum distance is set to 20, only the detections at a
distance of 20 and less will be displayed.
Setting a value in both fields will result in a range of distance to display.
Boxes 1 to 8
Check boxes 1 to 8 allow you to select which segments to display.