User Guide

66 | 127 © 2021 LeddarTech Inc.
10.4. File Menu
Table 21: File menu options
Option
Description
Save
Configuration
This option allows you to save the configuration for a specific device to a file (.lto)
from the Save as… dialog box.
This allows you to save settings and restore them in case of a system failure or to
revert to earlier settings. In addition, if you have more than one sensor and you
want to use the same configuration for all of them, save the configuration you want
to use for all your sensors. In this case, make sure to assign a different name to all
your sensors.
The sensors named differently will use the same configuration. See section 10.5.1
on page 72 for more details.
Load
Configuration
This option allows you to load the device configuration previously saved in the
system as an .lto file. Choose the desired device configuration from the Open
dialog box.
You can also retrieve the configuration that was stored with a record file. In case
of system failure, you can load a sensor configuration and use this sensor configu-
ration to collect signal data according to a set of parameters (scanning, distance
measurements, etc.) and then analyze the collected data or the information. In ad-
dition, if you have more than one sensor and you want to use the same configura-
tion for all of them, you must load the previously saved configuration that you want
to use for all your sensors. In this case, make sure to assign a different name to all
your sensors.
The sensors named differently will use the same configuration. See section 10.5.1
on page 72 for more details.
Start Recording
Stop Recording
Select the Start Recording option (shortcut: <F9>) to start recording detections in
an .ltl file that can later be reloaded and replayed.
Select the Stop Recording option (shortcut: <F9>) to stop recording detections of
the .ltl file.
See section 10.4.1.2 on page 67 for more details.
Replay
Once you have completed a recording, you can review it by selecting Replay in
the File menu.
The Position slider allows you to move directly to the desired position. The
Playback Speed slider allows you to adjust the speed of the recording playback.
See section 10.4.1.3 on page 68 for more details.
Start Data Logging
Stop Data Logging
Select the Start Data Logging option to start the log of receiving data or the event
log of the sensor. The event log is displayed in text format.
Select the Stop Data Logging option to stop the log of receiving data or the event
log of the sensor. The event log is displayed in text format.
See section 10.4.2.2 on page 71 for more details.
Quit
Select Quit to exit the Leddar Configurator software.