User Guide

54A0049_7.0_EN / Leddar Pixell – User Guide 49 | 127
Fig. 38: TE Connectivity AMP connector –
8 position AMPSEAL strain relief
(2 strain relief connectors required)
Fig. 39: Cable tie
The parts and accessories shown above are recommended by LeddarTech to ensure
compatibility with the Leddar Pixell connector interface. LeddarTech does not offer these
parts and accessories. Contact the appropriate vendors to obtain the parts you need.
Once assembled, the connector will look as shown below.
Fig. 40: Connector assembled
7.3. Connecting the Sensor – Diagrams
This section provides information on the recommended wiring options for the sensor. Refer to Table 17 on
page 48 for more details on the pinout and wiring.