User Guide

7.2. Power Connector Pinout and Wiring

Table 17: Cable connection

Pin #

Function

Description

Ground

Power supply ground

ETH+

Automotive Ethernet differential pair

ETH-

PPS- (Input)

Input for timestamp synchronization. Can be used as a trigger input.

PPS+ (Input)

V+ (11 V-52 V)

Power supply

Sync+ (Out)

One pulse per second output for multi-Leddar Pixell synchronization

Sync- (Out)

Recommendations on Connector Assembly

To assemble the harness, you need the following:

• One (1) automotive connector (Fig. 36). Also, refer to the pin positions in Fig. 37.

• RTV moisture-curing silicone

• Two (2) strain reliefs (Fig. 38)

• One (1) cable tie (Fig. 39)

1. Follow recommended assembly practices from AMPSEAL for this connector, referring to the instructions

named “Application Specification 114-16016” available on their website.

2. Seal each exiting wire with RTV moisture-curing silicone. To ease this step, you can fill the whole rear

pocket of the connector with silicone.

3. Install the strain relief (Fig. 38).

4. Install the black cable tie onto the strain relief, as shown in Fig. 40 on page 49.

Fig. 36: TE Connectivity AMP connector –

Automotive connector PLG 08POS F/H BLK

Fig. 37: Automotive connector pin positions

(cavity side as shown on the left)