User Guide

Page 65 of 109 Leddar T16 – User Guide
Table 27: Raw Detections Parameters
Parameters
Description
Range
Min Amplitude
Max Amplitude
The value entered in the Min Amplitude box shows
only detections of amplitude higher or equal to that
value.
The value entered in the Max Amplitude box will
show only detections of amplitude lower or equal to
that value. The maximum amplitude is set at 1024.0
by default.
Setting a value in both fields will result in a range of
amplitude to display.
0.0 to 1024.0
Min Distance
Max Distance
The minimum and maximum distance from where to
detect an object.
Maximum distance is set at 100.0 by default.
0 to 200
Segment
Select the segments that you want to display in the
detection results.
1 to 16
Freeze
Check the Freeze box to freeze the raw data and view
the information.
Enable
Disable
Distance (m)
Position of the detected object.
Varies
Amplitude
Quantity of light reflected by the object and measured
by the sensor.
0 to 128
Flags
The Flags parameter provides the status information
that indicates the measurement type (8-bit status
encoded as a bit field). See Table 28.
1 to 255