Instruction Manual

page6/9/2022 5
!
ATTENTION: Install in accordance with local and national building and electric codes.
TruGroove Drywall Trim Installation Instructions
ID-23
NOTE: For Standalone fixtures skip to step 15
12
Join Individual Modules
Gently slide housing modules together,
ensuring joiner aligners are engaged inside
the trim in the adjacent module.
Important: Joiner aligners must be fully
inserted to provide proper section
alignment.
13
Open Slots for Joiner
Bracket
Snap off the safety cover on joiner bracket
slots with a flat head screwdriver.
This only needs to be done on ends that
require joining.
14
Install Joiner Brackets
Install joiner brackets on each side of the
housing using supplied hardware.
Important: Hand tighten bracket screws
while supporting the housing on the
opposite side. Gradually alternate sides
while tightening.
Do not over tighten.
15
Raise Fixture(s) into
Ceiling Cut-out
Important: For continuous row modules,
start at one end and gradually raise each
module up one inch at a time. Repeat
process until housing is fully recessed and
housing trim touches drywall ceiling. Do
not stress the joint connection by tilting the
module, as damage can occur.
Slowly raise the modules into the ceiling
cut-out. Install the supplies spacers.
16
Trim Excess Cable
Trim suspension cable approximately 8
inches below the ceiling level. Tuck all
excess cable inside the upper wiring cavity.