Instruction Manual

page6/9/2022 4
!
ATTENTION: Install in accordance with local and national building and electric codes.
TruGroove Drywall Trim Installation Instructions
ID-23
Install fixtures
6
Prepare Fixtures
Suspend each module by inserting the
aircraft cables through the grippers on top
of the housing.
7
Insert Aircraft Cable
Gradually lift each module to approximately
12 inches below the ceiling.
8
Arrange boxed fixtures on floor in
specified mounting locations,
based on supplied layout drawings.
Match up each fixture based on
the spec tag and ID number
labelled on each fixture box for the
specified run.
Raise Fixture
12”
12”
9
Install CAT6 Cable
Insert CAT6 Cable at desired location.
10
Raise and Level Fixtures
Once the power connections are complete,
pull the aircraft cable to raise all modules to
just below the ceiling.
Important: Modules must be level relative
to each other if joining of sections is
required
11
Install Joiner Aligners
At joint location(s), gently tap provided
joiner aligners inside one module only. Two
joiner aligners are required for each joint.
Important: To insert aligners, tap gently
with a hammer until half is inserted into
the joiner channel. Be sure to engage the
dimple.
Dimple
engaged.