Instruction Manual

page6/9/2022 3
!
ATTENTION: Install in accordance with local and national building and electric codes.
Installation Preparation
3
Mount Kit
Install mounting brackets, suspension cables
and power feed(s) at required locations.
Mounting hardware (screws/ fasteners) are
supplied by others.
Maximum screw size # 10 (.190”).
4
Install Mounts and
Power Cables
Install a ‘C’ channel perimeter around the
ceiling cutout.
Important: See ceiling cut-out details on
page 2 & 3.
5
Install drywall ceiling and cut required
opening as shown in figure A on page 2 or
figure B on page 3.
END MOUNT
390ZA01
JOINT MOUNT
390ZA02
Install Drywall Ceiling
Prepare Ceiling: Continuous Runs
2
Ceiling Cut-out Details
Min
Max
MIN 2-5/8”
MAX 2-3/4”
Cutout Width:
Determine Locations
• Determine fixture location and
fixture type. Refer to figure B for
mount locations and cut-out length.
Install mount brackets and
suspension cables as shown below.
• Determine power feed location(s) -
refer to layout drawings. Install
power feeds as required and drop
below installed ceiling height.
• Build ceiling frame around fixture
cut-out to 2-5/8" to 2-3/4" width as
shown in figure B. Refer to layout
drawings for ceiling frame length.
POWER FEED
LOCATION 2"
3/8" MOUNTING OFFSET
2 LOCATIONS
FIXTURE LENGTH
For continuous run fixtures, the cut-out in
the drywall ceiling should be the same size
asthe overall fixture run length indicated on
the layout drawings +1/4 ".
TruGroove Drywall Trim Installation Instructions
ID-23
B
2-5/8”-2-3/4”
‘C’ Channel
Gyproc