User Manual

DAT file. Displaying “FE” indicates controller type is wrong.
Displaying “Fb” indicates there are too many pixels or too many
ports.
3. Two buttons are “MODE” and “SPEED”. Press “SPEED”, if
current status is “MODE”, it will switch to “SPEED”; if current
status is “SPEED”, it will adjust playing speed. Press “MODE”, if
current status is “SPEED”, it will switch to “MODE”; if current
status is “MODE”, short press to switch mode, long press to
switch status.
4. 0—7 represents eight kinds of modes, 0: DAT sequence; 1: DAT
speed; 3—7: auto music, mode 0 does not need music.
5. In “LED Build Software” sculpt settings, controller type must
select “SC”.
When making DAT file, select two lines of a controller, pixels
number of each line must be less than 1280; select one line of a
controller, pixels number must be less than 2560.
When making *hmc file, width and height must be less than 128
pixels. Width by height must be less than 2560 pixels, pixels can
not be overlapped and total pixels number must be less than 2560.
When *hmc files and DAT files are both in SD card, sculpt and
IC type must be the same.
If there is no *hmc file in SD card, select two lines of a