Manual

Design edit interface is the main interface, can enter into other two interfaces from this interface. In
design edit interface, you can create, edit, display and output design as controller data and so on. The
following is the toolbar. (Notice: before outputting controller data, light sculpt must be set up in light sculpt
window.)
Design edit toolbar
2.2 Lighting sculpt interface
Lighting sculpt interface
In main window menu, click “setting”-“setting sculpt” to enter into lighting sculpt interface. In this
window, you need to set light type, controller type, and connection mode and so on. When you save the file,
software will create controller configure file at the same time. The sculpt file is matching with actual
lighting project, when you change design don‘t need to modify sculpt file.